Enabling LBS on Cisco Autonomous AP.

I have been doing a lot of Aeroscout RTLS lately. For testing purposes I’ve configured an Autonomous AP, for use with local installation of Aeroscout Location Engine.

In this scenario, the only necessary information required is server address. This should be the address that all Aeroscout messages should be forwarded to.

Here the server is my company laptop, which at home has a reserved DHCP address of 192.168.1.102.

dot11 lbs Aeroscout
      multicast address 010c.cc00.0000
      server address 192.168.1.102 port 12091
      packet-type short
      channel-match
      interface Dot11Radio 0
!

After configuration, verify status with sh dot11 lbs

ap#sh dot11 lbs
LBS config table: 
LBS cfg: Aeroscout 
    multicast address: 010c.cc00.0000
    interface Dot11Radio 0
    server address: 192.168.1.102 port: 12091
    method: rssi, packet type: short
    report channel matched packets only
    pak_rx: 10555 pak_tx: 10555
ap#
This entry was posted in Aeroscout, Cisco, WiFi and tagged , , , . Bookmark the permalink.

Leave a Reply